M350 E16:16 I1 Interpolation enabled for Extruders ![]() M350 X16 Y16 U16 I1 Configure microstepping with interpolation M574 Z1 S2 Set endstops controlled by probe M574 X1 Y2 U2 Z2 S1 Set endstop configuration (X and Y endstops at low end, U endstop at high end, active high, Z Max Endstop ) M584 X0 Y6:7 Z1:2 U5 E3:4 U Axis for second X stepper, dual X and Dual Y and dualZ M569 P0 S0 Drive 0 goes backwards(change to S0 to reverse it) -X The X axis side just stays parked off to the side, extruding filament as if it was printing but nothing is being sent to it for movements.īelow is the Config.g (Everything under the network section in my file) Any help would be appreciated: When I start printing, the U Axis moves, and starts printing as expected in its half of the build area. I've set it up so that the printing happens with "Tool 2" "Extruder 1" in S3D, and the heaters are for T2. ![]() I am using Simplif圓D and I chopped the X width of the build area in half so that S3D works in the "box" each extruder has access to. I went through the guide on the Duet page for configuring multiple independent extruders, and have the config setup so that Tool 2 is the duplication setup. I have a custom IDEX machine that's been working great for a month or so now, and I finally calibrated the 2 hot ends so I can print duplicate objects with each extruder.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |